Machine Adjustment Procedures; Wheel Adjustment Bona Edge Ux 130; Abrasive Assembly Procedure - Bona Edge UX Mode D'emploi

Machine Adjustment Procedures

Wheel adjustment Bona Edge UX 130

1) The distance between the suction elbow and wheel
support should be approx. 16 mm.
Wheel adjustment Bona Edge UX 220
1) The distance between the suction elbow and wheel
support should be approx. 18 mm.
Footprint should be as above to get the best result.
Note! If the whole disc is flat and in full contact with the floor it will
create excessive resistance in the motor, leave circular scratch
marks, and the machine will be hard to handle.

Abrasive assembly procedure

1) Check that the machine is
turn off and unplugged from
power supply before remove
the old abrasive disc.
14
2) Ensure the Velcro surface of the disc is clean and select an
abrasive disc (178mm diameter) with a suitable grain which
does not have a damaged surface.
Only use abrasive discs with a diameter of 178 mm.
Bona Edge UX
3) Attach the new abrasive disc
on the Velcro surface of the
metal plate disc.