BERTO'S MACROS 700 Mode D'emploi page 113

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 118
Use only the accessories recommended by the
manufacturer.
Do not use the equipment to cook food directly.
For obtaining a good performance and energy savings,
use cookware suitable for electric cooking (check the
labels on the bottom): their bottom must be thick and
flat (see Fig. 6).
The diameters of the cooking vessels should be as big
as the cooking area you have chosen; if the diameter
is smaller, energy will be wasted; therefore, it is better
that the diameter is bigger. (See fig. 6)
The bottom of the cooking vessel must be clean and
dry as well as the cooking area.
During the initial uses of the appliance, an acrid or
burning smell may be detected. This will disappear
after two or three uses.
After use, the glass ceramic hobs are hot for a certain
amount of time. The residual heat indicators remain
lit until the glass is cool. Avoid touching and keep
children away until the residual heat indicator lights
go off.
These are very important regulations; if they are
neglected, the appliance may not perform properly or
the user may be placed at risk.
This appliance cannot be used by people (including
children) with impaired skills or without experience
and knowledge unless under the supervision of a
person responsible for their safety who provides
precise instructions about the use of the unit.
Keep children under supervision to make sure that
they don't play with the unit.
Pay attention to the floor around the unit as it might
be slippery.
Attention: the panels marked with the symbol
protect the user from accessing parts with voltage
higher than 230 V.
Attention: the panels marked with the
(danger of hot surfaces) warn of hot potentially
dangerous surfaces.
The A weighed noise pressure level is lower than 70
dB (A).
STARTING UP THE ELECTRIC PLATES
Turn on the switch upstream from the appliance.
To turn on the appliance, rotate the knob corresponding
to the cooking area you have chosen and select a position
from 1 to 6. The pilot light switches on to show which
appliance is operating.
Turn on the knob to the highest position (position no. 6)
and, when the maximum temperature is reached, turn the
knob to a lower position.
To turn off the plate, turn the knob to the "O" position.
6 to start cooking for maximum of 5/10 minutes
5 to cook at high temperature
4 to cook at average temperature
3 to continue cooking large quantities of food
2 to continue cooking small quantities of food
1 to keep food warm or melt butter
0 plate turned off.
STARTING UP THE ELECTRIC RADIANT HOTPLATE
Turn on the switch upstream the appliance.
To turn on the appliance, rotate the knob corresponding
to the cooking area you have chosen and the pilot light
switches on to show the appliance is operating.
Turn the knob again to set the cooking temperature you
prefer.
The appliance has 4 cooking areas; the whole surface is
heated.
We recommend that you turn the knob to the highest
position and, when the maximum temperature is reached,
turn the knob to a lower position.
To turn off each cooking area, turn the knob to the "O"
position.
STARTING UP INFRARED HOBS
Turn on the switch upstream from the appliance.
To turn on the appliance, rotate the knob corresponding to
the cooking area that you have chosen and the pilot light
will switch on to show that the appliance is operating (see
Fig. 7). The relevant area will start becoming incandescent.
Turn the knob again to set the cooking temperature that
you prefer.
To turn off each heating element, turn the knob to the "O"
position.
The cooking areas are shown by 2 or 4 indicator lights on
the hob.
These lights indicate high temperatures and operate even
when the appliance is off.
The lights are on until the temperature is low enough to be
symbol
safe for the user.
STARTING THE INFRARED COOKTOPS
WITH B-FLEX CONTROLS (see Fig. 12)
When the glass ceramic cooktop is switched off and the
power cord is connected to the mains, the "A" display will
show "OFF".
To switch the glass ceramic cooktop ON, keep the "B" knob
pressed for a few seconds and the display will show 0.
To change the cooking temperature, quickly press down
| 113
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Plus 600Lx900 topS900S700Maxima 900

Table des Matières