Playing Cds - Sony CDP-CE375 Mode D'emploi

Making digital hookups
If you have a digital component such as a
digital amplifier, D/A converter, DAT, or MD,
connect the component via the DIGITAL OUT
(OPTICAL) connector using the optical cable
(not supplied). Take off the cap and plug in the
optical cable.
Note that you cannot use the following
functions when making this connection:
• Fading In or Out (see page 12)
• Adjusting the output level using the
ANALOG OUT LEVEL +/– buttons on the
remote
POC-15
Optical cable (not supplied)
CD player
DIGITAL
OUT
OPTICAL
Note
When you connect via the DIGITAL OUT
(OPTICAL) connector, noise may occur when you
play CD software other than music, such as a CD-
ROM.
Transporting the player
Before transporting the player, follow the
procedure below to return the internal
mechanisms back to their original position.
1
Remove all the discs from the disc tray.
2
Press A OPEN/CLOSE to close the
disc tray.
"no dISC" appears in the display.
3
Wait for 10 seconds, then press
POWER to turn off the player.
Digital component
DIGITAL
INPUT
OPTICAL

Playing CDs

Loading a CD
1
Turn on the amplifier and select the CD
player position so that you can listen to
the sound from this player.
2
Press POWER to turn on the player.
3
Press AOPEN/CLOSE.
The disc compartment slides out.
4
Place a disc on the disc tray with the
label side up.
When you play a CD single,
place it on the inner circle
of the tray.
5
To place other discs, press DISC SKIP
and place the discs in the order you
want to play.
Each time you press the button, the disc tray
turns and you can place the discs in the
empty disc compartments. The player plays
the disc in front of you first.
6
Press AOPEN/CLOSE to close the disc
compartment.
Disc number
7
US