DeWalt DCV517 Guide D'utilisation page 12

The vacuum is designed to perform as a wet/dry unit with no
component changes required when changing from wet to dry, or dry
to wet pick up. This vacuum is for household use.
It is recommended that the tank be emptied of any dry contents prior
to being used for wet pick up to facilitate tank cleaning.
Installing and Removing the Battery Pack
(Fig. 3)
NOTE: For best results, make sure your
battery pack is fully charged.
To install the battery pack (G) into the tool
handle, align the battery pack with the rails
inside the tool's handle and slide it into
the handle until the battery pack is firmly
seated in the tool and ensure that it does not
disengage.
To remove the battery pack from the tool,
press the release button (H) and firmly pull
the battery pack out of the tool handle. Insert
it into the charger as described in the charger
section of this manual.
FUEL GAUGE BATTERY PACKS (FIG. 4)
Some D WALT battery packs include a fuel gauge which consists of
e
three green LED lights that indicate the level of charge remaining in
the battery pack.
The fuel gauge is an indication of approximate levels of charge
remaining in the battery pack according to the following indicators:
FIG. 3
To actuate the fuel gauge, press and hold the fuel gauge button (X).
A combination of the three green LED lights will illuminate designating
the level of charge left. When the level of charge in the battery is below
the usable limit, the fuel gauge will not illuminate and the battery will
need to be recharged.
G
H
NOTE: The fuel gauge is only an indication of the charge left on the
battery pack. It does not indicate tool functionality and is subject to
variation based on product components, temperature and end-user
application.
For more information regarding fuel gauge battery packs, please
contact call 1-800-4-D
www.dewalt.com.
10
75–100% charged
51–74% charged
< 50% charged
Pack needs to be charged
FIG. 4
X
WALT (1-800-433-9258) or visit our website
e