Assembling The Dosatron - dosatron D14 Série Manuel D'utilisation

ASSEMBLING THE DOSATRON

A
%
5
© DOSATRON INTERNATIONAL S.A.S / 19
Fig. 1
C
ASSEMBLY SHOULD BE CARRIED OUT WITHOUT THE USE OF TOOLS
The DOSATRON is delivered with :
- a mounting bracket,
- a suction tube with a strainer.
The bracket enables the DOSATRON to be fixed to a wall.
Snap the DOSATRON into the bracket by fitting the two lugs on one side of
the body (Fig. 1-A) into the corresponding holes in the bracket (Fig. 1-B), and
springing the bracket arms apart until the other 2 lugs click into place.
Remove the plastic caps (Fig. 1-C) which block the inlet and outlet of your
B
DOSATRON before connecting to the water supply.
RECOMMENDATIONS
%
5
The DOSATRON can be connected to the water supply by means of
Ø 3/4" [20 x 27 mm] bore flexible hose and hose tail fittings with hose clips.
Make certain that the water flows in the direction of the arrows on the motor
body.
The DOSATRON is delivered with a suction tube (cut it to the needed
length) enabling its use with a large capacity concentrate container.
The tube must be fitted with its strainer and weights.
The instructions for fitting the tube are to be found in the specific chapter.
NOTE : The maximum suction height is 13 vertical feet (4 meters).
Fit the tube, equipped with its strainer and its weight, and immerse it in the
solution to be injected.
Torque 20 N.m
thus 2kg.m
(remember : 1 N.m = 0.1 DaN.m)
© DOSATRON INTERNATIONAL S.A.S / 20