Denon AVR-591 Manuel De L'utilisateur page 57

1
Press AMP to set the remote
control unit to amplifier operation
mode.
2
MENU
Press .
The menu is displayed on the TV screen.
3
Use ui to select "Manual
Setup" – "Option Setup" –
"Remote Preset Codes" and then
press ENTER .
4-4.Option Setup
1.Volume Control
2.Source Delete
3.On-Screen Display
4.Remote Preset Codes
5.Quick Select Name
6.Display
7.Setup Lock
[ENT]:Select [RTN]:Back
4
Pressing ui, select the category
of device for preset registration.
Then press ENTER .
4-4-4.RC Preset Codes
Category Search
Blu-ray
CD
CD Recorder
CABLE
CABLE/PVR
DVD
[ENT]:Select [RTN]:Back
5
Pressing ui, select the first character of the brand
name. Then press ENTER .
Brand Search - DVD -
1
A
B
C
D
E
[ENT]:Select [RTN]:Back
• The first character is displayed as 1, A to Z. (Initials for the brand are
displayed for each category.)
For brand names that start with numbers, select "1".
6
Pressing ui, select the brand name. Then press
ENTER
.
Brand[1/1] - DVD -
Daewoo
Dantax
Denon
Disney
DSE
Durabrand
[ENT]:Select [RTN]:Back
• When there are several pages of brand names, the pages can be
switched by pressing the remote control unit's CH + or CH –.
NOTE
If the desired brand name is not listed, the supplied remote control
unit cannot control the device. Use the remote control unit supplied
with the device to be used.
7
The procedures for registering remote control codes
and remote control preset registration are displayed.
Category :DVD
Brand :DENON
Code[1/3]:30490
Setup Remote
1.Press [Source]button.
2.Press and Hold 3sec.
both[PowerON][DeviceON]
3.Input Code with [0-9]
4.Press any key to check
device[e.g.DeviceON]
[QUICK1]:OK [QUICK2]:NG
Registering preset codes
8
Press the input source button on which the preset
code is to be registered ( DVD , BD
V.AUX GAME TV
, or ).
TV
• For , only the preset code for the categories "TV", "TV/DVD", or
"TV/VCR" can be registered.
• For "TV", "TV/DVD", or "TV/VCR" categories, only the preset
TV
code for can be registered.
9
Hold POWER ON and DEVICE ON
simultaneously for more than 3 seconds.
The signal transmission indicator flashes twice.
10
0 – 9
Enter a five-digit code using
Press the buttons with an interval less than 10 seconds.
Category :DVD
Brand :DENON
Code[1/3]:30490
Setup Remote
1.Press [Source]button.
2.Press and Hold 3sec.
both[PowerON][DeviceON]
3.Input Code with [0-9]
4.Press any key to check
device[e.g.DeviceON]
[QUICK1]:OK [QUICK2]:NG
• When the code is registered:
The signal transmission indicator flashes twice.
• When the code is not registered correctly:
The signal transmission indicator slowly flashes once. Perform
from step 8 again.
• When an input number is not correct:
POWER ON
Press once then perform the operations from step
8 again.
11
Operate the device being used to check the operation.
QUICK SELECT 1
• If the device is operating, press
Go to step 12.
QUICK SELECT 2
• If the device is not operating, press
Go to step 13.
ENGLISH
, SAT/CBL , DOCK ,
pressed
.
.
.
53