Denon AVR-591 Manuel De L'utilisateur page 12

ENGLISH
Set up speakers (Audyssey ® Auto Setup)
3
Set up
the remote control unit
n Set up the operation mode
AMP
Press to set the remote control
unit to amplifier operation mode.
Press AMP
8
Remote control operation
buttons
Preparation
4
Connect the setup microphone to the
SETUP MIC jack of this unit.
When the setup microphone is
connected, the following screen is
displayed.
3-1.Audyssey Auto Setup
MultEQ
Please place microphone
at ear height at
main listening position.
Pre Assign:
Normal
Start
Cancel
[ENT]:Select [RTN]:Back
Here, we explain setup using the example of
5.1-channel speaker playback.
For setting other than 5.1-channel surround,
select "Pre Assign" and perform steps 3 to 4 of
"Set up speakers" (vpage 29).
5
Use ui to select "Start" and then
press ENTER .
When measuring begins, a test tone is
output from each speaker.
• Measuring requires several minutes.
If "Cancel" is selected
"Cancel Auto Setup?" is displayed on the TV
screen. If "Yes" is selected, "Audyssey Auto
Setup" closes.
Move the cursor
(Up/Down/Left/Right)
Step 1
Speaker Detection
6
The detected speakers are displayed.
Step1:Speaker Detection
MultEQ
Front Sp. :Yes
Center Sp. :Yes
Subwoofer :Yes
Surround Sp. :Yes
Next
Retry
[ENT]:Next
NOTE
If a connected speaker is not displayed, the
speaker may not be connected correctly. Check
the speaker connection.
7
Use ui to select "Next" and then
press ENTER .
NOTE
If "Caution" is displayed:
Go to "Error messages" (vpage 10), check
any related items, and perform the necessary
procedures.
If the problem is resolved, return and restart
"Audyssey Auto Setup".
When performing Audyssey Auto
Setup over again
ui
Press to select "Retry", and then press
ENTER
.
When measuring has stopped
ui
q Press to select "Cancel", then press
ENTER
.
ENTER
w Press o p to select "Yes", then press
Setting up the speakers again
Repeat the operation from step 4 of Preparation
Confirm the setting
Step 2
Measurement
8
Move the setup microphone to
position 2, use to select "Next",
ui
and then press ENTER .
The measurement of the second position
starts. Measurements can be made in up to
six positions.
Step2:Measurement
MultEQ
Please place microphone
at ear height at
2nd listening position.
Next
Calculate
Cancel
[ENT]:Next
If you want to omit measurements from the next
position onward, select "Calculate".
(Go to Step 3 Calculating )
9
Repeat step 8, measuring positions 3
to 6.
When measurement of position 6 is
completed, a "All the measurements were
finished." message is displayed.
Step2:Measurement
MultEQ
All the measurements
were finished.
Calculate
Retry
Cancel
[ENT]:Calculate
.
.
Return to previous menu