Storing Only The Desired Stations; Other Functions; Adjusting The Sound Characteristics; Quickly Attenuating The Sound - Sony CDX-R3000 Mode D'emploi

If FM stereo reception is poor
— Monaural Mode
During radio reception, press (SENS)
(BTM) repeatedly until "MONO"
indicator appears in the display.
"MONO" indicator is displayed.
The sound improves, but becomes monaural
("ST" disappears).
To return to normal radio reception mode, press
(SENS) (BTM) again ("MONO" indicator turns
off).
Storing only the desired
stations
You can manually preset the desired stations on
any chosen number button.
1
Press (SOURCE) repeatedly to select
the radio.
2
Press (MODE) repeatedly to select the
band.
3
Press (SEEK) (+) or (SEEK) (–) to tune
in the station that you want to store.
4
Press the desired number button ((1)
to (6)) for 2 seconds until "MEM"
appears.
The number button indication appears in the
display.
Note
If you try to store another station on the same number
button, the previously stored station will be erased.
12

Other Functions

Adjusting the sound
characteristics
You can adjust the balance, fader, low pass filter
and subwoofer volume.
1
Press (SEL) repeatedly until "BAL,"
"FAD," "LPF" or "SUB" appears.
Each time you press (SEL), the item changes
as follows:
LOW* 1 t MID* 1 t HI*
BAL (left-right) t FAD (front-rear) t
LPF (low pass filter)*
SUB (subwoofer volume)*
*1 When EQ3 is activated (page 14).
*2 When "SUB" is selected (page 13).
*3 The cut off frequency is adjustable to 78 Hz,
125 Hz or OFF.
*4 The volume level is adjustable between –10
and +10 steps. (Below –10, "ATT" is displayed.)
2
Press the volume +/– button to adjust
the selected item.
Note
Adjust within 3 seconds after selecting the item.
Quickly attenuating the
sound
Press (ATT).
"ATT" appears in the display.
To restore the previous volume level, press
(ATT) again.
1 t
2 3
* t
2 4
*