General Operation; Information Banner; Electronic Programme Guide (Epg) - Telefunken TF3250HX847LU Mode D'emploi

After then, the active antenna selection OSD appears
on the screen:
By pressing " " or " " buttons, set active antenna
mode as on or off.
If an active antenna is connected to your TV, you can
select this option as On. Antenna power should be
"Off" when standard antenna is used instead of the
active antenna. See "Confi guration Menu" in the
following sections for more information.
Press OK button on the remote control to continue
and the following message will be displayed on the
screen:
• To select the "Yes" or "No" option, highlight the item
by using " " or " " buttons and press OK button.
The IDTV will automatically tune to the transmission
channels, searching for digital terrestrial TV broadcasts
and displaying the names of channels found. This
process will take a few minutes. To cancel searching,
you can press M button at any time during the
process. The following OSD will be displayed during
the automatic search:
After Automatic Search is completed, the following
message, asking for analogue channel search,
appears on the screen.
To search for analogue channels, select "Yes". TV
switches to the analogue TV mode. A menu will be
displayed to search for analogue channels .
Set Language item by pressing " " or " " button.
Press " " or " " button to highlight Country item and
01_[GB]_MB36_MASQUE_HDIDTV-MPEG4_NICKEL7_32847W_3900UK_10067001_50162077.indd 12 01_[GB]_MB36_MASQUE_HDIDTV-MPEG4_NICKEL7_32847W_3900UK_10067001_50162077.indd 12
then use " " or " " to set. Press " " or " " button to
highlight TXT. Language. Set TXT Language by using
" " or " " button. To cancel, press the BLUE button.
When fi nished, press OK or RED button to continue
and the following OSD will be displayed:
After automatic tuning is fi nalized, a programme list
will appear on the screen. In the programme list you
will see the programme numbers and names assigned
to the programmes.
If you do not accept the locations and/or the names
of the programmes, you can change them in Program
table. For details, see the section, "Program table".

General Operation

Pressing the "
watching television programmes will switch the TV
set to the digital terrestrial television broadcasting.

Information Banner

• Whenever you change the channel using the P + or
P - button or numeric buttons, the TV displays the
broadcast picture along with an information banner
at the bottom of the screen. This will remain on the
screen for approximately a few seconds.
• The information banner can also be displayed by
pressing the
the TV. Pressing
banner.
If the selected channel is locked, you must enter
the correct four digit key to view the channel. In this
case, a dialog box asking for the lock key will be
displayed:

Electronic Programme Guide (EPG)

Some, but not all, channels send information about
the current and next events. Please note that event
information is updated automatically. If there are no
event information data available for channels,EPG
will be displayed with blanks.
• Press EPG button to view the EPG menu.
• Press " " or " " buttons to navigate through
channels.
English - 12 -
" button at any time while
button at any time while watching
button again removes the
25.12.2009 18:49:09 25.12.2009 18:49:09