Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Overload Protection
In order to protect the operator, motor and tool, the wall chaser is equipped
with an electronic and thermal overload protection.
Thermal:
In case of permanent overload, a thermocouple protects the
motor against destruction. In this case, the tool switches off
automatically and can only be restarted after a certain
cooling period (approx. 2 minutes). The cooling period
depends on the heating of the motor winding and the
ambient temperature.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an electric
specialist. Due to its design, the machine needs a minimum of care and
maintenance. However, the following points always have to be observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the
machine.
In case of failure, a repair has to be carried out by an authorised
service workshop.
Auto-stop brushes
In order to protect the motor, this power tool is equipped with auto-stop
brushes. When the carbon brushes are worn out, the machine switches itself
off. In this case both brushes must be replaced at the same time with original
brushes by an electrical specialist.
Environmental Protection
Raw material recycling instead of waste disposal
To avoid damages on transportation, the power tool has to be delivered in a
sturdy packing. Packaging as well as unit and accessories are made of
recyclable materials and can be disposed accordingly.
The tool's plastic components are marked according to their material,
which
makes
differentiated because of available collection facilities.
it
possible
to
remove
environmental
25
friendly
and
Publicité
Table des Matières
