Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Cautions
• It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
• If airbags or any other shock-absorbing
equipment are in your car, contact the store where
you purchased this unit or the car dealer before
installation.
Notes
• When mounting on the dashboard, remove the visor clip
carefully from the microphone , then attach the flat-
mount base to the microphone .
• Before attaching the double-sided tape , clean the
surface of the dashboard with a dry cloth.
Using the wired remote control
When using the steering wheel remote
control
Installation of the connection cable RC-SR1 is
required before use.
1
To enable the steering wheel remote control, select
[General] [Steering Control] [Custom]
make the registration.
When the registration is complete, the steering
wheel remote control becomes available.
Notes on installing the connection cable RC-SR1
• Refer to the support site for details then connect each lead
properly to the appropriate leads. Making an improper
connection may damage the unit.
URL: https://www.sony.com/am/support
• Consulting the dealer or an experienced technician for
help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [Steering
Control] in [General] to [Preset].
Using the rear view camera
Installation of the rear view camera (not supplied) is
required before use.
The picture from a rear view camera connected to
the CAMERA IN terminal is displayed when:
– the back lamp of your car lights up (or the shift
lever is set to the R (reverse) position).
– you press HOME, then touch [Rear Camera].
Installation
To install the unit and the display securely, be sure
to follow the steps to in order.
Before mounting the unit (page 15)
Mounting the unit in the dashboard (page 16)
Attaching the joint cover (page 16)
Setting up the display (page 16)
Making sure the mounting positions of the
display (page 18)
Organizing the USB cable (page 18)
Attaching the display to the unit (page 18)
For your safety
After mounting the display to the unit, make sure
that the display does not interfere with normal
driving operations such as blocking the driver's
view or getting the cables tangled.
Before mounting the unit
Before mounting the unit in the dashboard, arrange
the USB extension cables.
to
USB cable connection diagram
1
Remove the cable cover, store the USB
extension cable (short) to the groove of
the unit, then attach the cable cover.
Position the USB cable so that its connector
(male) comes to the front side of the unit.
Cable cover
*
* USB connector (male)
Smartphone, USB device
(not supplied)
Release the lock of the
cable cover when
removing it.
15
GB
Publicité
Table des Matières
