Stopping The Generator; Generator Coupling - WORMS ACCESS 2000i Manuel D'utilisation

Do not put foreign objects into the plug receptacle.
NOTE
The economy control switch have to be turn "OFF" in order to have an higher engine speed during
nominal use. If the generator set is connected to multiple loads or electric appliances, please first
connect to one with the highest starting power, then, the one with the second highest starting power,
and connect others one by one, each with a lower starting power than the preceding one, finally,
connect the one with the lowest starting power.
This generator is equipped with a circuit breaker which acts as security of overload. If the electric
current distribution is interrupted during using, this can be due to one overload which causes the circuit
breaker release or of the devices which is defective. When the circuit breaker or no-fuse breaker turns
off during operation, the generator is overloaded or the appliance is defective. In that case, wait for a
few moments, remove the overload cause, then turn off generator and start it again.

7. STOPPING THE GENERATOR

1. Turn off the economy control switch by pushing on "OFF" (FIG.MU-ACC-10)
2. Turn off the power switch of the electric equipment and unplug the cord from receptacle of the
generator
3. Allow engine about 3 minutes to cool down at no-load before stopping
4. Turn the 3 positions switch knob to the position "OFF". (FIG. MU-ACC-02)
5. Close the Fuel tank cap air vent knob when engine is totally cooled. (FIG. MU-ACC-14)
NOTE
To stop the engine in an emergency, turn the generator switch to the OFF position.

8. GENERATOR COUPLING

Parallel terminals (MU-ACC-12) allow the coupling between two Access 2000i thank to the use of the
parallel cables. This coupling permits to increase the continuous output power to 3.0 kW with a current
of 13A and a maximum output power of 3.2 kW. The special parallel cables are only applicable to the
parallel operation of two Access 2000i. (Sell as option)
Make sure that only parallel cables are used for parallel running. Other cables are forbidden. It cannot
be used for paralleling three or more than three generators.
Before start the parallel mode make sure that generator are turned off, Switch knob have to be on OFF
position. (FIG. MU-ACC-02)
1. Take one cable and link it between the two access 2000i red terminals, take the second cable and
link it between the two access 2000i black terminals. (FIG. MU-ACC-25)
EN
FR
ES
IT
RO
41