Stopping The Generator - WORMS Access 2200 XL Manuel D'utilisation

Do not put foreign objects into the plug receptacle.
NoticE
This generator is equipped with a circuit breaker which acts as security of overload. If the electric
current distribution is interrupted during using, this can be due to one overload which causes the circuit
breaker release or of the devices which is defective. When the circuit breaker or no-fuse breaker turns
off during operation, the generator is overloaded or the appliance is defective. In that case, wait for a
few moments, remove the overload cause then rearm the circuit breaker by pushing the button situated
near the grips of exit.

9. stoppiNg thE gENErAtor

1. Turn off the power switch of the electric equipment and unplug the cord from the receptacle of
the generator.
2. Allow the engine about 3 minutes to cool down at no-load before stopping.
3. Turn the engine switch to the position "OFF" (
position.
4. Switch the ignition button to the "OFF" (
5. Close the fuel cock.
46
o
)
o
) position.
AC Circuit Breaker
On-Off Switch
Fuel Valve
OFF
ON