Introduction; Dear Customer; Symbols On The Machine - McCulloch CS 340 Manuel D'utilisation

Dear customer!

Thank you for choosing a McCulloch product. You are
thereby part of a story that started long ago, when the
McCulloch Corporation started its manufacturing of
engines during World War II. In 1949, when McCulloch
introduced its first light one-man chainsaw, woodworking
would never be the same again.
The line of innovative chainsaws would continue over the
decades, and business was expanded, first by airplane
and kart engines in the 1950s, then by mini chainsaws in
the 1960s. Later, in the 1970s and 80s, trimmers and
blower vacs were added to the range.
Today, as a part of the Husqvarna group, McCulloch
continues the tradition of powerful engines, technical
innovations, and strong designs that have been our
hallmarks for more than half a century. Lowering fuel
consumption, emissions and noise levels are of top
priority to us, as is improving safety and user-friendliness.
We certainly hope that you will be satisfied with your
McCulloch product, as it is designed to be your
companion for a long time. By following this operators
manual's advice on usage, service, and maintenance, its
lifespan can be extended. If you should need professional
help with repair or service, please use the Service Locator
at www.mcculloch.com.
McCulloch has a policy of continuous product
development and therefore reserves the right to modify
the design and appearance of products without prior
notice.
This manual can also be downloaded at
www.mcculloch.com.

Symbols on the machine:

WARNING! Chain saws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator's hands must be
used to operate the chain saw.
Never operate a chain saw holding it
with one hand only.
6 – English

INTRODUCTION

Contact of the guide bar tip with any
object must be avoided.
WARNING! Tip contact may cause the
guide bar to move suddenly upward and
backward (so-called kickback), which
may cause serious injury.
The engine is stopped by switching the
ignition off using the stop switch.
Air purge.
Refuelling.
Chain oil fill.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
You will find the following labels on your chain saw:
The Emissions Compliance Period referred to on the
Emission Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal emissions requirements.
Maintenance, replacement, or repair of the emission
control devices and system may be performed by any
nonroad engine repair establishment or individual.
1154657-49 Rev.5 2013-12-10
XX