Clarke FOCUS 28 Disc Manuel D'utilisation page 15

How To Prepare the Machine For Operation
How To Install The Brush Or Pad on the BOOST
machine
To install the brush or pad on the BOOST machine, follow
this procedure:
1. Turn the key switch "ON".
2. Put the brush switch in the "UP" position.
3. Turn the key switch "OFF".
4. Go to the side of the machine.
5. Press on a brush or pad under the flex plates. See
figure 15.
NOTE: When using a black pad, position pad on head.
Lower head and operate momentarily to affix pad to
pad driver (if you have difficulty, position pad on
floor and lower head then operate.)
How To Remove The Brush Or Pad on the BOOST
machine
To remove the brush or pad from the machine, follow this
procedure:
1. Turn the key switch "ON".
2. Put the brush switch in the "UP" position.
3. Turn the key switch "OFF".
4. Go to the side of the machine.
5. Pull downward on the brush or pad until it releases from
the flex plates. See figure 16.
Clarke ®
Operator's Manual (EN) - Focus Rider
ENGLISH EN
Figure 15
Figure 16
- 15 -