Ice And Water Dispenser Controls; Switching The Appliance On; Operating Tips; Setting The Language - Thermador T18ID Guide D'utilisation

Ice and Water Dispenser Controls

Water Dispense Button.
Ice Cube Dispense Button.
Crushed Ice Dispense Button.
Lock Button for the Ice and Water Dispenser
Control Panel (childproof lock).
To lock and unlock, hold down the button
for 3 seconds.
Switch light with low brightness On and Off.
Switch light with full brightness On and Off.

Switching the Appliance On

Switch the appliance On with the POWER Button.
The appliance begins to cool. Light turns on when
the door is open.
,
CAUTION:
Keep hands and fingers away from front and rear
openings of the freezer door or freezer drawer
when closing. Risk of injury to hands
or fingers.
Never allow children to climb on or play with
the freezer door.

Operating Tips

When the appliance has been switched on, it may
■
take several hours until the set temperature is
reached.
The fully automatic No Frost system ensures that
■
the Freezer Compartment remains free of ice.
Defrosting is not required.

Setting the Language

The Display Languages can be changed according
to the table in the chapter "Special Functions", section
"Setup Mode".
To change the Display Language:
1. Press the SETUP Button.
2. Press the ¾ or ¿ Selection Button, until the set
language is displayed.
3. Press the @ or A Setting Button, until the desired
language is displayed.
4. Press the SETUP Button, in order to store
the settings.
The set temperature is displayed again on the
Display Panel.

Setting the Temperature Unit

The temperature can be displayed in degrees
Celsius (°C) or degrees Fahrenheit (°F).
1. Press the SETUP Button.
The first menu (Temperature Unit) is displayed.
2. Press the @ or A Setting Button in order to switch
between degrees Fahrenheit (°F) and degrees
Celsius (°C).
3. Press the SETUP Button, in order to store
the settings.
The set temperature is displayed again on the
Display Panel.

Setting the Temperature

Freezer Compartment

(can be selected from +7 °F (-14 °C) to –9 °F (-23 °C))
We recommend a setting of 0 °F (-18 °C).
1. Press the ¾ Selection Button.
2. Set the temperature with the @ (warmer) or A
(cooler) Setting Buttons.
en-us
9