Before Starting The Equipment - EINHELL RT-BS 75 Mode D'emploi

Anleitung RT_BS_75_SPK1:_

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
5.1 Dust extraction
5.1.1 Installing the dust extractor adapter
(Figure 3/Item 15)
Slide the dust extractor adapter (15) on to the
connection for the dust extractor (6).
You can then connect a suitable dust extractor (a) to
the dust extractor adapter (15) (dust extractor not
supplied).
This will provide excellent dust extraction on the
workpiece.
Check that all the parts are properly connected.
Important. The vacuum cleaner you use for the
extraction work must be suitable for the workpiece
material.
5.1.2 Installing the dust bag (Figure 4/Item 14)
Slide the dust bag (14) on to the connection for the
dust extractor (6). Follow the instructions above in
reverse order to remove the dust bag.
The dust is extracted straight from the
sanding/grinding belt into the dust bag.
Important.
The use of the dust bag or dust extractor via the dust
extractor adapter is absolutely essential for health
reasons.
5.2 Adjusting the additional handle
(Fig. 5/Item 2)
Slacken the screw (1) and move the additional handle
(2) to its optimal position. Lock the additional handle
(2) in place by tightening the screw (1).
5.3 Changing the sanding / grinding belt
(Fig. 6-7/Item 13)
Pull the clamping lever (12) to the outside to
relieve the tension in the sanding/grinding belt.
Pull the used sanding/grinding belt off the drive
rollers.
Slide the new sanding/grinding belt on to the
drive rollers.
Ensure that the direction of the sanding/grinding
belt (arrows on the inside of the sanding/grinding
15.09.2008 17:05 Uhr Seite 11
belt) is identical to the direction of the belt
sander/grinder (arrow over the rear drive roller).
Press the clamping lever (12) to the rear to
tension the sanding/grinding belt.
5.4 Adjusting the position of the belt
(Fig. 8/Item 8)
Hold the belt sander/grinder with the
sanding/grinding plate at the top.
Switch on the belt sander/grinder.
By turning the setting screw (8) the belt position
should be set so that the sanding/grinding belt is
at the center of the two drive rollers.
5.5 Moving sanding/grinding belt cover
(Fig. 9 – 10/Item 9)
Important.
The moving sanding/grinding belt cover may
only be swung upwards if the pushbutton (7) has
been pressed.
Press the pushbutton (7) and at the same time
swing the cover (9) upwards.
Release the pushbutton.
The cover will lock in its end position.
To swing the cover back down again, press the
pushbutton (7) again. The cover can then be
swung downwards.
6. Starting up
6.1 Switching ON/OFF (Fig. 11)
To switch on:
Press the ON/OFF switch (5).
Continuous operation:
Secure the switch (5) with the locking button (4).
To switch off:
Press the ON/OFF switch (5) briefly.
The machine can be operated on a temporary or
permanent setting.
6.2 Setting the belt speed (Fig. 12/Item 3)
You can select the belt speed by turning the setting
knob (3).
PLUS direction:
Increase belt speed
MINUS direction:
Reduce belt speed
GB
11