Low Battery Warning - DeWalt DCD991 Guide D'utilisation

English
Fig. G
Fig. I
5
6
Three-Speed Gearing (Fig. G–I)
The three-speed feature of your tool allows you to shift
gears for greater versatility. To select speed 1 (highest
torque setting), turn the tool off and permit it to stop. Slide
the gear shifter all the way forward. Speed 2 (middle
6
torque and speed setting) is in the middle position. Speed 3
(highest speed setting) is to the rear.
nOTE: Do not change gears when the tool is running.
Always allow the drill to come to a complete stop before
changing gears. If you have trouble changing gears, depress
and release the trigger switch and try again.
Worklight (Fig. J)
The worklight 3 and its switch
foot of the tool. The worklight is activated when the
trigger switch is depressed. The low
and spotlight modes can be changed by moving the
19
switch on the foot of the tool. If the trigger switch remains
depressed, the worklight will remain on in all modes.
When on low 17 and medium
automatically turn off 20 seconds after the trigger switch
is released.
10
Fig. H
5
6
20 are located on the
, medium
17 18
18 settings, the beam will
Fig. J
17
18
20
Spotlight Mode
The high setting is the spotlight mode
will run for 20 minutes after the trigger switch is released.
Two minutes before the spotlight will shut off, it will flash
twice and then dim. To avoid the spotlight shutting off,
lightly tap the trigger switch.

WARNING: While using the worklight in medium
or spotlight mode, do not stare at the light or
place the drill in a position which may cause
anyone to stare into the light. Serious eye injury
could result.

CAUTION: When using the tool as a spotlight, be sure
it is secured on a stable surface where it will not cause
a tripping or falling hazard.

CAUTION: Remove all accessories from the chuck
before using the drill as a spotlight. Personal injury or
property damage could result.

Low Battery Warning

When in spotlight mode and the battery is nearing
complete discharge, the spotlight will flash twice and then
dim. After two minutes, the battery will be completely
discharged and the drill will immediately shut down. At this
point, replace with a fresh battery.

WARNING: To reduce the risk of injury, always have a
back-up battery or secondary lighting available if the
situation warrants it.
Keyless Single Sleeve Chuck (Fig. K–M)

WARNING: Do not attempt to tighten drill bits (or
any other accessory) by gripping the front part of the
chuck and turning the tool on. Damage to the chuck
and personal injury may result. Always lock off trigger
switch and disconnect tool from power source when
changing acces sories.

WARNING: Always ensure the bit is secure before
starting the tool. A loose bit may eject from tool
causing possible personal injury.
Your tool features a keyless chuck with one rotating sleeve
for one-handed operation of the chuck. To insert a drill bit or
other accessory, follow these steps.
1. Turn tool off and disconnect tool from power source.
2. Grasp the black sleeve of the chuck
and use the other hand to secure the tool as shown
in Figure H. Rotate the sleeve counterclockwise (as
3
19
19 . The spotlight
4 with one hand