Operating Procedures - Rona RNS-18G-001 Guide D'utilisation

IMPORTANT SAFETY INSTRUCTIONS
!
23. STAY ALERT. Keep hands and body away from the path of any potential fired
fastener. Watch what you are doing & use common sense. Don't operate any tool
when you are tired or under the influence of drugs or alcohol. Check prescriptions to
determine if there could be a problem.
24. PREVENT ELECTRIC SHOCKS. Prevent body contact with grounded surfaces:
pipes, radiators, ranges, and refrigerator enclosures. Before driving fasteners into
walls, floors, or wherever "live" electrical wires may be encountered, check whether
there is a danger of shock.
25. KEEP WORK AREA CLEAR of obstructions.
26. STORE IDLE EQUIPMENT. When the tool is not being used, it should be cleaned,
and stored in a clean dry place out of the reach of children.
27. EMPLOYERS must enforce compliance with the safety warnings and all other
instructions in this manual. Keep it available for use by everyone assigned to use
this tool.
WARNING! The warnings, cautions, and instructions detailed in this manual cannot
cover all possible conditions and situations that occur. It must be understood by the
operator that COMMON SENSE AND CAUTION ARE FACTORS that cannot be built
into this product, but MUST BE SUPPLIED BY THE OPERATOR.
SPECIFICATIONS
n
This RNS-18G-001 nailer/stapler shoots the most common air staple used in North
America today as well as 18 gauge brad nails. It can be used for cabinet making and
furniture assembly, door and window casing manufacturing, aluminum and vinyl siding
installation, soffit work, trim and moulding application, picture framing and applications
where gluing is necessary, but clamping is impractical.
n
Shoots all sizes of industry standard 18 gauge narrow crown staples (90 series 1/4"
crown), 5/8" (15 mm) to 1-9/16" (40 mm) in length
n
Shoots industry standard 18 gauge brad nails in the following sizes: 3/4" (20 mm),
1" (25 mm), 1-3/16" (30 mm), 1-1/4" (32 mm), 1-9/16"(40 mm), 1-3/4" (45 mm) and
2" (50mm)
n
Operating pressure (min. to max.): 60-100 PSI / 413 to 690 kPa / 4.13 to 6.9 bar
n
Air consumption: 4-5 cfm / 113-141 litres per min.@ 80 PSI / 551 kPa
n
Air inlet: 1/4" NPT
n
Padded hand grip.
n
Belt loop hook.
n
Adjustable exhaust deflector.
n
Tool weight: 3.4 lb (1.5 kg)
n
Pkg. weight: 4.0 lb (1.8 kg)

OPERATING PROCEDURES

UNPACKING THE TOOL
Check and make sure one of each of the following are all included.
RNS-18G-001 Combination Nailer Stapler

S3 hex key

S4 hex key

Small bottle of air tool oil

Operating instructions

11
070601