22
▪
never disassemble the device. In correct assembly may cause electric shock or
fire.
▪
never short circuit the device or connect the inlets and outlets of the device using
metal objects. Only use the supplied connecting cables to connect the device to
a battery.
▪
If an extension cable is used, the cable diameter must be sufficient for the power
required by the device.
▪
check the input voltage (230 V Ac) and ensure that it corresponds to the mains
voltage; otherwise the device may be damaged.
▪
Always make sure that the device is disconnected from the mains when you
connect it and disconnect it to a battery.
▪
Always connect the positive clamp (red) to the positive battery pole (not connec-
ted to the chassis of the car, marked with P or +).
▪
then connect the negative clamp (black) to the car chassis, away from the bat-
tery casing of the car, away from the battery and the fuel line. the charger can
then be connected to a suitable power socket.
▪
After charging, first disconnect the charger from the power supply. then, in
this sequence, disconnect the cable to the car chassis (-), and then the battery
connection (+).
▪
Do not look at the battery when connecting the charger to the power supply.
Warning!
▪
never try to charge damaged, non-rechargeable or frozen batteries.
▪
this charger is only suitable for the listed batteries (maintenance-free, sealed,
lead-acid batteries (SLA) or gel batteries) and may not be used to charge
non-rechargeable, nicd or other types of batteries. Do not use it for any other
purposes.
▪
Do not use the charger to charge dry cell batteries. these may explode and
cause injury to persons or material damage to property.