Options; Before First Use - Electrolux ESL5335LO Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

12
www.electrolux.com

7. OPTIONS

Desired options must be
activated every time before
you start a programme.
It is not possible to activate
or deactivate options while a
programme is running.
Not all options are
compatible with each other.
If you select non compatible
options, the appliance
automatically deactivates
one or more of them. Only
the indicators of the still
active options are on.
If an option is not applicable
to a programme, the related
indicator is off or it flashes
quickly for a few seconds
and then goes out.
Activating options can affect
the water and energy
consumption as well as the
programme duration.
7.1 XtraDry
Activate this option to boost the drying
performance. With XtraDry on, the
duration of some programmes, water
consumption and the last rinse
temperature can be affected.
XtraDry is a permanent option for all
programmes other than
need not to be selected at every cycle.
In the other programmes the setting of
XtraDry is permanent and it is

8. BEFORE FIRST USE

1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
automatically used in next cycles. This
configuration can be changed at any
time.
Activating XtraDry deactivates
TimeManager and vice versa.
How to activate XtraDry
Press
The related indicator is on.
The display shows the updated
programme duration.
7.2 TimeManager
This option increases the pressure and
the temperature of the water. The
washing and the drying phases are
shorter.
The total programme duration decreases
by approximately 50%.
The washing results are the same as
with the normal programme duration. The
drying results can decrease.
How to activate TimeManager
Press
The display shows the updated
and
programme duration.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not put dishes in
the baskets.
After starting the programme, the
appliance recharges the resin in the
water softener for up to 5 minutes. The
Every time
activated, XtraDry is off and
needs to be chosen
manually.
.
. The related indicator is on.
is

Publicité

Table des Matières
loading

Table des Matières