Installing The Navigation System; Installation Notes - Pioneer AVIC-F9210BT Manuel D'installation

Section
04 Installation
Installing the navigation
system

Installation notes

! Do not install the navigation system in
places subject to high temperatures or hu-
midity, such as:
— Places close to a heater, vent or air con-
ditioner.
— Places exposed to direct sunlight, such
as on top of the dashboard.
— Places that may be exposed to rain,
such as close to the door or on the vehi-
cle's floor.
! Install this navigation system in an area
strong enough to bear its weight. Choose a
position where this navigation system can
be firmly installed, and install it securely. If
this navigation system is not securely in-
stalled, the current location of the vehicle
cannot be displayed correctly.
! Install the navigation unit horizontally on a
surface within 0 degrees to 30 degrees tol-
erance (within 5 degrees to the left or
right). Improper installation of the unit with
the surface tilted more than these toler-
ances increases the potential for errors in
the location display, and might otherwise
cause reduced display performance.
30°
5°
16
Engb
! When installing, to ensure proper heat dis-
persal when using this unit, make sure you
leave ample space behind the rear panel
and wrap any loose cables so they are not
blocking the vents.
! The cords must not cover up the area
shown in the figure below. This is neces-
sary to allow the amps and navigation me-
chanism to dissipate heat.
! The semiconductor laser will be damaged
if it overheats, so don't install the naviga-
tion unit anywhere hot —for instance, near
a heater outlet.
5°
5 cm
10 cm
Leave ample space
Do not cover this area.
Dashboard