Spare Parts; Optional Accessories; Maintenance And Cleaning Of The Machine; Noise Emission - Nuova Mondial Mec MANTA Série Mode D'emploi

2] Tilt the motor to an angle of 45ø.
3] Move the motor carriage to the centre of the machine.
4] Tighten the two locking rings against the motor carriage. PHOTO 12 PAGE 3
5] Pull out the four carrying handles and grasp them. Lift the machine (2 PERSONS ARE REQUIRED). PHOTO 13
PAGE 3
6] The machine can also be transported with a forklift truck, a pallet loader or self-balancing forks
construction site crane. When not fitted with legs, the standard space of 10 cm is available beneath the
machine for the passage of the forks of any of the above lifting devices.
N.B.
PLEASE CONSULT THE ACCOMPANYING DIAGRAM ON PAGES 08/9
Identify the required part on the diagram, note down the corresponding part number and order it from your local dealer,
clearly specifying the type, ITALY or EUROPE version, model and serial number of the machine.
Extension table, Extension rollers, Long side square, Diagonal square adjustable 0-45ø. PHOTO 14, 15, 16 PAGE 3.
1] Before carrying out any work on the machine, disconnect the plug from the power socket.
2] Regularly change the water in the tank (REF.20), using the drain plug to empty it. Remove any sludge deposits in the
tank. PHOTO 17 PAGE 3.
3] To remove the bench surfaces, unscrew the bolts (see photo) with the service tools provided. The bolts should be
changed when they start to deteriorate, and should be greased every time they are remounted. PHOTO 18
PAGE 3
4] Clean the pump (REF.15) every day by submerging it in a container of clean water.
5] If the machine is stopped for a long period, before being used again the pump must be removed and inspected to
check that there are no deposits blocking the vanes. The vanes should be turned with a screwdriver. PHOTO
19 PAGE 3
6] Grease the slide bushes (REF. 32) and the threaded lifting bar (REF.38) once a month. PHOTO 21 PAGE 3
7] If the machine is to be out of use for a long period, it is advisable to clean it and to empty the tank, so as to avoid the
possibility of water coming into contact with electrical parts. The slide bushes (see photo 21 page 3 and
REF.4 on diagram) should also be lubricated.
THE MANUFACTURER RESERVES THE RIGHT TO MAKE ANY MODIFICATIONS DEEMED NECESSARY TO THE
The noise emission of this machine was measured in a semi-anechoic chamber complying with standard ISO 3745-77
(test carried out by CSR, Rimini). The values below are calculated on a working day of 8 hours. These values may
decrease by 3 dba if exposure is reduced by 50%.
The following results were obtained when running without load, using a blade with standard sectors and the standard
blade guard:
1] Running without load L.ep (operator position) 73.4 dba
2] In operation 98.4 dba
Better results can be obtained by using these accessories:
- Silenced blade guard, available on request.
- Silenced blade, available on request.
The following values can be obtained:
1] Running without load 73.0 dba
2] In operation 88.5 dba
*
If the machine is lifted to a height of over 2 metres, it must be secured tothe forks with ropes or other fastenings.
Nuova Mondial Mec S.R.L.
MANUALE SERIE MANTA
MANTA SERIES MANUAL

SPARE PARTS

HOW TO ORDER SPARE PARTS

OPTIONAL ACCESSORIES

MAINTENANCE AND CLEANING OF THE MACHINE

MACHINES PRODUCED, WITHOUT GIVING PRIOR NOTICE.

NOISE EMISSION

*
attached to a
pag.18