General Information; Purpose Of This Manual; Identifying The Machine; Photo - Nuova Mondial Mec MANTA Série Mode D'emploi

NB.
EVERY MACHINE IS TESTED AND CHECKED BEFORE LEAVING OUR FACTORY.
Read the instructions and advice given in this manual with care. Important information is provided on: safe installation,
use and maintenance of the machine.
The manufacturer declines all responsibility for damage caused by failure to follow the instructions and advice given in
this manual.
After removing the packing, check that all parts of the machine are free from damage. If they are not, contact your local
dealer.
Packing materials must be disposed of at an authorized collection point.
THEY ARE NOT TO BE USED FOR CHILDREN'S GAMES!
Any necessary repairs to the machine must be carried out only by a specialized technician.
IN THE CASE OF MALFUNCTION, DISCONNECT THE MACHINE BY REMOVING THE PLUG FROM THE POWER
SOCKET.
When the machine is thrown away, it must be made unserviceable. Remove the plug and cut the power cable. Consign
the machine to a collection point for bulky wastes.
The purpose of this manual is to assist the operator in the correct use of the machine, to provide information on the
relevant safety regulations currently in force in the European Community, and to eliminate any risks that might be
caused by incorrect use of the machine.
This machine must be used only for the purpose for which it has been made, namely the cutting of marble, granite, brick
products, ceramic tiles, etc. Any other use is to be considered improper, and consequently dangerous. The
manufacturer cannot be held responsible for any damage to persons or things caused by improper, incorrect or
unreasonable use of the machine.
The identification plate bearing the type or model of the machine, with the serial number and the motor name and data
is located on the front of the machine. PHOTO 1 PAGE 3
TYPE
MINI MANTA 60
MINI MANTA 90
MINI MANTA 60 ALL.
MANTA 65 ALL.
MANTA 85 ALL.
MANTA 65
MANTA 85
MANTA 100
MANTA 120
MANTA 150
MANTA 150
SPECIAL
MANTA 200
NB.
For the voltage and the power of the machine to make reference the identification nameplate.
N.B.:
FOLLOW THE INSTRUCTIONS BELOW WHEN INSTALLING THE MACHINE
1] Before connecting the machine to a power socket, it is essential to check that the data shown on the identification
plate correspond exactly to the type of power supply available.
Nuova Mondial Mec S.R.L.
MANUALE SERIE MANTA
MANTA SERIES MANUAL

GENERAL INFORMATION

KEEP THIS MANUAL CAREFULLY.

PURPOSE OF THIS MANUAL

IDENTIFYING THE MACHINE

TECHNICAL DATA

CUT
DEPTH
LENGTH
Cm
Cm
60 5,5
90 5,5
60 5,5
65 11
85 11
65 11
85 11
100 11
120 11
150 11
150 13
200 13

INSTALLATION

Ø DISC MOTOR
mm Kw
230 1,1
230 1,1
230 1,1
350 2,2
350 2,2
350 2,2
350 2,2
350 2,2
350 2,2
350 2,2
400 4
400 4
LxBxH WEIGHT
Cm Kg
100x47x55 49
130x47x55 55
100x47x55 32
107x66x77 61
127x66x77 66
107x66x77 90
127x66x77 105
140x66x77 120
160x66x77 160
197x66x77 180
197x88x77 210
250x88x77 260
pag.16