Makita TM3000C Manuel D'instruction page 5

Adjusting the orbital stroke rate
► 1. Dial
The orbital stroke rate is adjustable. To change the
orbital stroke rate, turn the dial between 1 and 5. The
higher the number is, the higher the orbital stroke
rate is. Preset the dial to the number suitable for your
workpiece.
NOTE:
• The dial cannot be turned directly from 1 to 5 or
from 5 to 1. Forcing the dial may damage the
tool. When changing the dial direction, always
turn the dial moving it through each intermediate
number.
Constant speed control
Electronic speed control for obtaining constant speed.
Possible to get fine finish, because the orbital stroke
rate is kept constant even under load condition.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing application
tool (optional accessory)
WARNING:
• Do not install application tool upside down.
Installing application tool upside down may
damage the tool and cause serious personal
injury.
• Install attachment tool in the correct direction
according to your work. Application tool can be
installed at an angle of every 30 degree.
2
3
► 1. Application tool installation bolt 2. Holes in the
1
application tool 3. Protrusions of the tool flange
► 1. Application tool installation bolt 2. Hex wrench
3. Tighten
Put an application tool (optional accessory) on the tool
flange so that the protrusions of the tool flange fit in the
holes in the application tool and secure the application
tool by tightening the bolt firmly with the hex wrench.
When using sanding application tool, mount the application tool
on the sanding pad so that it matches the sanding pad direction.
The sanding pad has a hook and loop type fitting system
which allows easy and rapid fitting of a sanding paper.
As sanding papers have holes for dust extraction,
mount a sanding paper so that the holes in a sanding
paper match those in the sanding pad.
To remove a sanding paper, raise its end and peel it off.
Loosen and remove the application tool installation bolt
using a hex wrench and then take off the application tool.
► 1. Application tool installation bolt 2. Holes in the
application tool 3. Adapter 4. Protrusions of the tool
flange
5 ENGLISH
1
1
1
2
3
4
2
3