Items Supplied; Scope Of Use; Safety Instructions - EINHELL 41.327.41 Mode D'emploi D'origine

Masquer les pouces Voir aussi pour 41.327.41:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 7
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.

Scope of use

Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufactur-
er will be liable for any damage or injuries of any
kind caused as a result of this.

1. Safety instructions

1.1 Safety instructions for working with
copressed air and blasting guns
Compressors and lines reach high temperatures
during operation. Avoid contact! Risk of burns!
Gases or vapours drawn in by the compressor
have to be kept free of constituents that may
cause fire or explosions inside the compressor.
When you disconnect the hose coupling, hold
the coupling element in your hand to prevent
injury from the whiplashing hose.
Wear goggles when working with the blow-out
gun. Injuries may easily result from foreign
bodies and blasted parts.
Never point the blow-out gun at other persons
and never use it to clean clothes that are still
being worn.
Keep these safety instructions in a safe place.

2. Items supplied

1 x 3-piece accessory set (1-3)
3. Quick-release coupling
Connect
Push the nipple on your compressed air hose into
the quick-release coupling, the sleeve will automati-
cally spring forwards.
Disconnect
Pull back the sleeve and remove the hose.
Important. As you release the hose coupling,
hold the hose coupling part in your hand to pre-
vent injuries caused by the hose being thrown
backwards.
The compressed air hose is also fitted with a quick-
lock coupling to which accessories can be connected
as described above.
4. Instructions for the 3-piece
accessory set
For information on the correct use of the acces-
sories, please refer to the following overview.
Compressed air hose
For connecting to a compressed air source.
Blow-out pistol (Figure 1)
Working pressure in bar: 3-8
Range of applications:
For cleaning and blowing out hollow spaces or
hard-to-reach areas, as well as for cleaning
soiled equipment.
The infinitely variable trigger lever allows an
exact dosing of compressed air.
Tire pressure gauge (Figure 2)
Working pressure in bar: 0-8
Range of applications:
The tire pressure gauge allows you to inflate
tires easily and exactly. Use the pressure gauge
to check the tire pressure. If the tire pressure is
too high, you can reduce the pressure with the
integrated relief valve (b).
GB
5

Publicité

Table des Matières
loading

Table des Matières