Wohler VIS 200 Instructions De Service page 21

2
4
Fig. 17: Camera head holder with
locking button (1), locking button
(2) and clamp (3).
Fig. 18: Camera head holder with
open clamp; the notch is marked
by a fletch.
Fig. 19: Camera head Ø 40 mm
mounted into the camera head
holder
• Press and hold the locking button (1) of the
camera head holder and open the clamp.
1
3
• Put the camera cable into the notch of the
camera head holder. The camera head should
be positioned directly behind the notch.
• Close the clamp so that the button snaps into
place.
Detachable camera heads may also be clamped
into the camera head holder, when the camera
head holder has already been fixed at the Trolley.
Mounting the camera head
NOTE!
EN
21