Upgrading The Operating System - Viscount Chorale 2 Mode D'emploi

Chorale 2 - Chorale P31
Viscount

10.3 UPGRADING THE OPERATING SYSTEM

Upgrading the organ's operating system requires use of a MIDI file (extension .MID) reader, by means of
which the data in the upgrade file can be transmitted to the organ. A hardware device used for MIDI
sequencing, or a computer software package capable of processing this type of file, may be used. Connect
the MIDI data output port of the transmitter device (which may be the MIDI OUT connector of a hardware
module or of a serial or USB / MIDI interface or Joyport if a computer is used) to the [MIDI IN] connector
of the Chorale.
Start the updating procedure; when the organ starts to receive the data, the display will show :
now the display will start to show a percentage of the data received.
At the end of the procedure, the following video page is displayed:
When the organ is switched on, if the display shows one of the following video page:
RELEASE CHK SUM
If the display looks like the one shown on the left, you must turn the organ off and switch it back on whilst
holding down the [FIELD
updating procedure. If the display looks like the one shown on the right it is possible to re-transmit the
MIDI files straight away without having to manually recall the updating procedure.
OPERATING SYSTEM
_____Updating_______
Boot Release: 1.09
OPERATING SYSTEM
_____Updating_______
Loading = 14 %
Boot Release: 1.09
UPDATE
COMPLETED
Error
], [FIELD ] and [EXIT] buttons at the same time. You can then repeat the
___WAIT TO UPDATE___
Enable Midi
Boot Release: 1.09
70
Owner's Manual