Selecting The Channels; Program Change Message Transmission - Viscount Chorale 2 Mode D'emploi

Owner's Manual
o TX/RX FILTER: MIDI filter setting.
Use the [FIELD ] and [FIELD
Otherwise, press [EXIT] to exit the MIDI submenu and return to display of the SETTING MENU.

8.1 SELECTING THE CHANNELS

To set the MIDI transmission and reception channels, select the TX/RX CHANNEL field in the MIDI
submenu:
The three fields displayed correspond to the organ's three sections. The number alongside identifies the
transmission and reception channel for the section concerned.
As usual, use the [FIELD
[VALUE +] and [VALUE -] to select the channel required.
Now press [EXIT] to return to the MIDI menu and save the settings made.
N.B.
- It is not possible to set different reception and transmission channels for the same section.
- MIDI 16 channel cannot be selected since it is the system channel used for the exchange of
internal codes between Viscount instruments.

8.2 PROGRAM CHANGE MESSAGE TRANSMISSION

The MIDI Program Change (PG) message allows a specific sound or program (patch) to be recalled in a
connected unit. Therefore, you can use this function to select the voice required from a remote module
(such as an expander) connected to the [MIDI OUT] port directly from the organ itself.
To display the relative video page, select the SEND PROG. CHANGE field in the MIDI menu and press
[ENTER]:
To transmit a PG message, locate the cursor on the section to which the MIDI channel of choice is
associated and use the [VALUE +] and [VALUE -] buttons to set the number of the PG required.
] and [ENTER] buttons to select the function required.
_TX/RX MIDI àçÜììäë_
PEDAL
MANUAL I : 2
MANUAL II: 1
] and [FIELD ] buttons to locate the cursor on the display fields and
_òäìâ PROG. CHANGE__
PEDAL:
MANUAL I:
MANUAL II:
65
Viscount
: 4
OFF
1
OFF
Chorale 2 - Chorale P31