Setting The Tremulants; Selecting The Type Of Reverb - Viscount Canticus 50 Guide Rapide

4.1 SETTING THE TREMULANTS

The TREMULANT function can be used to set the modulation speed and depth of the tremulants
for each manual. When the TREMULANT field is selected in the SET-UP menu, the display will
show the page:
which shows the two manuals and, on the bottom line, the Depth (modulation depth) and Speed
(modulation speed).
As the display states, the number to the left of the "/"symbol represents the Depth, while the
number to the right is the Speed. To change the values use the [CURSOR] buttons to move the
cursor and the encoder [VALUE].
After making all the changes required, press [ESC] to return to the SET-UP menu and to save the
new settings.

4.2 SELECTING THE TYPE OF REVERB

The REVERBERATION TYPE function allows eight types of reverb to be selected, with different
diffusion and propagation of the reverberated signal, which can be used to simulate the
reverberation of the sound generated by the organ in different ambient settings.
As described in chap. 3, the [REVERB] potentiometer on the centre panel is used to adjust the level
of reverb.
To set the type of ambient effect required, select the REVERB field in the SET-UP menu and press
[ENTER] the following page will appear:
Use the encoder to select the type of reverb and press [EXIT] to save the selection and return to the
SET-UP menu.
NOTE
The organ's internal reverb also affects any incoming signals through the [INPUT] sockets on
the rear panel.
Quick Guide – Viscount Canticus50
EN - 16