Panasonic CS-XE9SKUA Instructions D'utilisation page 7

AUTO
COMFORT
To maximize comfort
AUTO COMFORT
To select Room Freeze
RFP
Protection
RFP
• When selected, the unit will circulate the air in
High mode for monitoring the temperature. When
the sensor detects the temperature drops below
46°F / 8°C the compressor/heat pump operation
begins, when the temperature reaches 50°F /
10°C, the compressor stops and repeat this cycle.
To adjust airfl ow direction
AIR SWING
(Remote control display)
• Keeps the room ventilated.
• In COOL/DRY mode, if AUTO is set, the fl ap
swings left/right and up/down automatically.
• In HEAT mode, if AUTO is set, the horizontal fl ap
is fi xed at the predetermined position.
The vertical fl ap swings left/right after the
temperature rises.
• Do not adjust the fl ap by hand.
Auto Restart Control
• If power is resumed after a power failure, the
operation will restart automatically after a period
of time with previous operation mode and airfl ow
direction.
• This control is not applicable when TIMER is set.
See "To learn more..." for details.
To set the timer
2 sets of ON and OFF timers are available
to turn ON or OFF the unit at different preset
times.
1 2 3
TIMER TIMER
ON SET
1 2 3 3
OFF CANCEL CANCEL
1 Select ON or OFF
timer
• Each time pressed:
Cancel
2 Set the time
3 Confi rm
• To cancel ON or OFF timer, press
to select respective
• If timer is cancelled manually or due to power
failure, you can restore the timer again by
pressing or
ON OFF
then press .
SET
• The nearest timer setting will be displayed and
will activate in sequence.
• When ON Timer is set, the unit may start
earlier (up to 35 minutes) before the actual
set time in order to achieve the desired
temperature on time.
• Timer operation is based on the clock set in
the remote control and repeats daily once set.
For clock setting, please refer to Quick guide.
Note
POWERFUL/ AUTO
ECONAVI
QUIET COMFORT
, ,
• Can be activated in all modes and can be
cancelled by pressing the respective button
again.
• Cannot be selected at the same time.
Example:
OFF at 22:00
OFF
2
SET
TIMER
or
ON OFF
or then press .
CANCEL
to select respective or
7