Grex G4.1 Sécurité Et Instructions D'utilisation page 16

7.1. Open the chin strap (see specific instructions) and pull the front of the left cheek
pad towards the inside of the helmet to undo the snap fastener from the left
frame (Fig. 11). Repeat the same operation on the right side of the helmet.
7.2. Release the roll neck left eyelet from the left frame (Fig. 12). Repeat the same
operation on the right side of the helmet.
7.3. Release the liner left rear flap from the support fixed to the inner polystyrene
shell by slightly deforming the shell edge and slightly pulling the comfort pad-
ding towards the inside (Fig. 13). Then repeat the same steps to remove the
central flap as well as the right flap.
7.4. Remove the left and right side flaps of the comfort padding from the cavities
between the inner polystyrene cheek pads and the outer shell inner side frames
(Fig. 14).
7.5. Hold the left front part of the liner and pull it upwards in order to remove the
corresponding liner flap from the support fixed to the polystyrene inner shell (Fig.
15). Then repeat the same steps for the central front and right flap.
7.6. Remove the chin strap left band from the cheek pad slot (Fig. 16). Repeat the
same operation on the right side of the helmet.
7.7. Completely remove the liner from the helmet.
8. Inner Comfort Padding Assembly
8.1. Insert the chin strap left band in the cheek pad slot (Fig. 16). Repeat the same
operation on the right side of the helmet.
8.2. Insert the left front flap of the liner into its seat on the support fixed to the poly-
styrene inner shell and push it downwards until it is completely locked. Follow
the same steps for the central and right flap (Fig. 15).
8.3. Insert the right and left side flaps of the liner, pushing them into the cavities bet-
ween the inner polystyrene cheek pads and the outer shell inner side frames
(Fig. 14).
8.4. Insert the rear right, central and left flaps of the liner into the corresponding
seats on the support fixed to the polystyrene inner shell by slightly deforming
the shell edge (Fig. 13). Push the flaps until they are fully hooked onto the
support.
8.5. Hook the roll neck left eyelet to the left frame (Fig. 12), making sure that the
frame central air intake is free. Push the cheek pad padding in line with the snap
fastener on its back by fastening it to the attachment seat of the frame fixed to
the shell (Fig. 11). Then pull the chin strap left band towards the inside of the
helmet. Follow the same steps on the right side of the helmet.
NOTE: Check the correct assembly of the liner front area by lifting and lowering
the VPS. These movements should be smooth. If this is not the case, repeat
steps 7.5 and 8.2.
WARNING
- Remove the inner comfort padding only when cleaning or washing is required.
- Never use the helmet before completely and correctly reassembling its inner
comfort padding.
- Delicately hand-wash in lukewarm water (max. 30° C) and neutral soap.
16