Grex G4.1 Sécurité Et Instructions D'utilisation page 15

might cause fogging and/or formation of condensation on the VPS, which
entails a reduction of visibility and/or sharpness of vision: in this case, deac-
tivate the VPS.
- In case of rain, the direct contact of raindrops with the scratch-resistant and
fog-resistant treated VPS quickly reduces sharpness of vision, thus causing
scarce visibility: in this case, deactivate the VPS.
- The special VPS fog-resistant treatment is usually sensitive to high temperatu-
res or heat sources. In this case, contaminations caused by contact with other
materials might occur. These contaminations will cause marks and stains to
develop. In these cases (e.g. when the helmet is kept in the top case on hot
days), it is recommended to make sure the VPS is not touching other materials.
5. VPS Disassembly
To remove the sunscreen from the helmet, open the visor completely and lower the
VPS by pushing the slider completely upwards (Fig. 8 B).
5.1. Hold the central part of the sunscreen, press it slightly towards the inner part of
the helmet and simultaneously pull the sunscreen downwards until its upper
grip pawl has been removed from the shell (Fig. 9).
5.2. Hold the left side part of the sunscreen and pull it towards the front of the hel-
met (Fig. 10). Repeat the same operation on the right side of the helmet.
6. VPS Assembly
To remove the sunscreen, open the visor completely and push the slider completely
upwards (Fig. 8 B).
6.1. Insert the sunscreen left end into the left side guide until the grip pawl is hooked
into the shell housing (Fig. 10). Repeat the same operation on the right side of
the helmet.
6.2. Press the sunscreen slightly towards the inside of the helmet near its upper grip
pawl while pushing it in the seat between the outer and inner shells (Fig. 9).
WARNING
- Push the left side slider completely downwards (Fig. 8 A) and upwards (Fig. 8 B)
to make sure that the VPS works properly. If necessary, repeat the above-men-
tioned steps.
- If the VPS opening/closing mechanisms are damaged or not working properly,
please contact a Grex authorized dealer.
- Do not use the helmet if the VPS has not been assembled properly.
- Since the VPS does not assure you the same protection as the one provided by
the visor, it has to be used only when the helmet visor is lowered.
REMOVABLE INNER COMFORT PADDING
7. Inner Comfort Padding Disassembly
To remove the inner comfort padding, lift the VPS and open the visor completely (see
instructions above).
15