Grex G4.1 Sécurité Et Instructions D'utilisation page 12

INSTRUCTIONS FOR USE
The G4.1 helmet can be used with two configurations (Fig. 1): with or without
visor. Using the helmet in its full configuration - with closed visor - definitely
guarantees a higher level of protection.
The side plates - which should be assembled if the helmet is used without visor
- are available on the product itself, in the box or as accessory / spare parts -
depending on the version of the product.
VISOR
1. Visor Disassembly
1.1. Lift and release the left safety cover from its lateral latch (Fig. 2).
1.2. Turn the latch 90° towards the front of the helmet (Fig. 3).
1.3. Remove the latch from the helmet by pulling it outwards so that the latch inner
bayonet "A" comes out of its housing in the visor mechanism (Fig. 4).
1.4. Remove the visor by holding its side end and bending it outwards so that the
hole "B" of the visor comes unhooked from the mechanism and the inner pin
"C" comes out of its housing in the mechanism (Fig. 5).
1.5. Follow the same steps on the right side of the helmet.
When using the helmet without visor, follow the instructions below starting from
step 2.2.
2. Visor Assembly
2.1. Place the left part of the visor on the visor mechanism, paying particular atten-
tion to insert the inner pin "C" and the hole "B" respectively in the lower part
and in the special circular projection of the mechanism (Fig. 5).
2.2. Place the left side latch on the corresponding mechanism and insert the inner
bayonet "A" in its housing in the side mechanism (Fig. 4).
NOTE: The left and right safety covers and lateral latches are different from
each other and are marked on their back as R (Right) and L (Left).
2.3. Turn the latch 90° towards the back of the helmet. Carry out this operation by
pushing the latch towards the inside of the helmet (Fig 3).
2.4. Fix the latch by positioning the safety cover and then pressing it against the
latch (Fig. 2). Make sure the cover is firmly attached to the latch.
2.5. Follow the same steps on the right side of the helmet.
WARNING
- Always ensure that the latches and the safety covers have been correctly
assembled and that they grip well to the side mechanisms.
- Make sure that the mechanisms are working properly. Open and close the
visor, making sure that the mechanisms hold it in the different positions. If
necessary, repeat the above-mentioned steps.
- Do not use the helmet if the visor, the lateral latches and the safety covers have
not been assembled properly.
- Should any of the side mechanisms fail or be damaged, please contact a Grex
authorized dealer.
12