Maintenance And Care - Franke AQLT0109 Mode D'emploi

18. Maintenance and care

The fitting must be checked and maintained at regular intervals, depending on the
water quality and in accordance with the local conditions and rules and regulations
applicable at the site.
Maintain the following components:
• Shower head (see
• Filters (see
• Non-return valve (see
Use suitable cleaning agents which do not attack the fitting in a proper manner and
rinse with water after use. High-pressure cleaners must not be used for cleaning.
Removing the shower panel
For some maintenance tasks, the shower panel must be removed.
Caution!
Do not allow the shower panel to hang by the connecting hoses.
Water connection from above:
18.1 Close the water volume regulators.
a: closed
b: open
18.2 Trigger the fitting.
18.3 Disconnect the water supply.
18.4 Release the screws on the shower panel.
18.5 Unhook the shower panel.
18.6 Insert the side of the shower panel into the suspension rail.
Water connection from rear:
18.7 Release the screw on the shower panel.
18.8 Unhook the shower panel.
18.9 Insert the side of the shower panel into the suspension rail.
18.10 Close the water volume regulators (see
18.11 Trigger the fitting.
18.12 Disconnect the water supply.
Chapter 20.)
Chapter 21.)
Chapter 24.)
Work step 18.1).
- 10 -