Maintenance; Lubrication; General Maintenance - RIDGID R4210 Manuel D'utilisation

MAINTENANCE

WARNING:
When servicing, use only identical replacement
parts. Use of any other part can create a hazard or
cause product damage.
WARNING:
Always wear eye protection with side shields marked
to comply with ANSI Z87.1 during product operation.
If operation is dusty, also wear a dust mask.
WARNING:
Before performing any adjustment, make sure the
tool is unplugged from the power supply. Failure to
heed this warning could result in serious personal
injury.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, carbon dust, etc.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. They contain
chemicals that can damage, weaken, or destroy
plastic.
Electric tools used on fiberglass material, wallboard,
spackling compounds, or plaster are subject to accelerated
wear and possible premature failure because the fiberglass
chips and grindings are highly abrasive to bearings, brushes,
commutators, etc. Consequently, we do not recommend
using this tool for extended work on these types of materials.
However, if you do work with any of these materials, it is
extremely important to clean the tool using compressed air.

LUBRICATION

All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrication
is required.
WARNING:
To ensure safety and reliability, all repairs should be
performed by a qualified service technician at an
authorized service center to avoid risk of personal
injury.
Some areas will require infrequent lubrication. You will need
to apply:
 Automotive oil directly to the slide bars.
 Light oil or a pressurized light spray oil to the arm pivot
shaft.
 Light oil or a pressurized light spray oil to the torsion
spring.
NOTE: Do not apply oil to the bevel lock assembly or to the
miter lock assembly.
39 - English