Velleman PIR415 Mode D'emploi page 4

 Protect this device from shocks and abuse. Avoid brute force
when operating the device.
 Protect the device against extreme heat and dust.
 Indoor use only. Keep this device away from rain, moisture,
splashing and dripping liquids.
 Familiarise yourself with the functions of the device before
actually using it.
 All modifications of the device are forbidden for safety reasons.
Damage caused by user modifications to the device is not covered
by the warranty.
 Only use the device for its intended purpose. Using the device in
an unauthorised way will void the warranty.
 Damage caused by disregard of certain guidelines in this manual
is not covered by the warranty and the dealer will not accept
responsibility for any ensuing defects or problems.
4. Installation
Refer to the illustrations on page 2 of this manual.
The installation must be carried out by a qualified person.
1. Choose a proper location for the sensor. Avoid places where
temperature changes frequently, e.g. near air conditioners or
heating devices. Also, avoid moving obstructions or objects in the
detection field of the sensor to prevent unnecessary activation.
2. The PIR sensor must be installed inside a hole, which is max.
14 mm in diameter. The controller can be installed on the other
side of the wall, inside a dropped ceiling or, behind a false wall.
Leave sufficient space (at least 2 cm) around the controller for
ventilation.
Notes:
 The lead wires of the sensor are ± 20 cm long. When mounting
the controller on the other side of a wall, drill a hole of at least
14 mm for the connector and wires to go through.
 Make sure the controller is accessible at all times when installing
inside a dropped ceiling or behind a false wall. However, it should
be sufficiently protected to avoid accidental touching!
3. Electrical wiring must be present at the installation location.
4. Deactivate and remove the fuse of the electric circuit on which
you want to install the device.
5. Connect the sensor to the controller [2]. The connector fits only
one way, do not force.
6. Set the DIP switches [3]:
V. 07 – 11/06/2018
PIR415
4 ©Velleman nv