Sony VPL-CS4 Mode D'emploi page 9

seconds. During this time, you
cannot light up the ON/STANDBY
indicator with the I / 1 key.
For details on the LAMP/COVER and
the TEMP/FAN indicators, see on
pages 32, 33.
6 Security lock (right side)
Connects to an optional security cable
(Kensington's).
The security lock corresponds to
Kensington's MicroSaver
System.
If you require further information,
contact
Kensington
2855 Campus Drive
San Mateo, CA 94403
in North America
Phone: 800-235-6708
Fax: 800-247-1317
Outside North America
Phone: 847-541-9500
Home page address:
http://www.kensington.com/
7 Control panel
For details, see "Control Panel" on
page 10.
8 Ventilation holes (exhaust)
9 Focus lever
Adjusts the picture focus.
q; Zoom lever
q;
q; q;
Adjusts the picture size.
qa Adjuster adjustment buttons
qa
qa qa
For details,see "How to use the
adjuster" on page 10.
qs AC IN socket
qs qs qs
Connects the supplied AC power cord.
qd Ventilation holes (intake)/air
qd
qd qd
filter cover
qf Connector panel
qf qf qf
®
Security
qg Rear remote control detector
qg qg qg
How to open/close the front cover
To open the front cover
Press the OPEN button.
The front cover is opened and set on the top
panel of the projector.
To close the front cover
Restore the front cover by hand.
Note
Do not tilt the projector out of the range of
the adjuster setting when you open the front
cover. If the projector is tilted too much,
the front cover opens speedily or slowly.
Notes
• Do not place anything near the
ventilation holes as it may cause
internal heat build-up.
• Do not place your hand or objects
near the ventilation holes as it may
cause the air coming out heat build-
up.
• To maintain optimal performance, clean
the air filter every 300 hours.
For details, see "Connector Panel" on
page 11.
(SIRCS receiver)
Location and Function of Controls
9
GB