Ergon BE3 Enduro Mode D'emploi page 16

17
EN
Helmet Carrying
The adjustable helmet holder allows a full-face helmet to be
carried (Fig. 2), or a standard bicycle helmet (Fig. 3). To do
this, pull the helmet straps out of the upper and lower pockets
and guide it through the openings in the helmet. Then place the
helmet on the backpack (Fig. 2/3) and fasten the belt to the
proper loops in accordance with the numbering printed on
them (Fig. 1).
1 2
3
Fig. 1
Carrying arm / leg protectors
Arm / Leg protectors can be carried using the vertical
straps on the underside of the backpack. To do this, open
the lowest outer pocket and pull out the two carrying belts
as far as possible (Fig. 1). Place the protectors at the lower
end of the backpack and then fasten the carrying belt to
the corresponding loops (Fig. 2).
Fig. 1
4
Fig. 2
Fig. 2
Fig. 3
Rain Cover
Take the rain cover out of the rain cover pocket. Thread the
ends of the hip belt through the guides on the rain cover
1
. Pull the rain cover up over the top edge of the pack.
2
E P
Back
2
1