Ergon BE3 Enduro Mode D'emploi page 13

ERGON BIKE ERGONOMICS
5. For correct positioning, the green indicator stripe must
appear as a thin line at the lower edge of the opening. That is,
the opening should not be completely covered. For the size
adjustment „S", it must appear at the upper edge of the back
plate, so that it roughly lines up with the upper edge of the
backpack.
7. Then thread the carrying belt
the opening in the back plate noted in point 5, and pull it tight.
2
9. Insert the carrying belt
press it firmly onto the corresponding Velcro area.
from behind and through
2
back into the hollow space and
2
2
6. Engage the Velcro again for rough fastening by pressing on
the back area.
8. Release the Velcro again by pulling the strap.
1
10. Then press the loop
restore the Velcro connection.
1
and the entire back area firmly to
1
1
14
EN