EN
Installation Manual: Fitting the water heater
Specific case:
Fitting a vertical wall-mounted water heater
on a tripod
The use of a tripod is mandatory when fitting a water tank with
a capacity greater than 100 L on a non load-bearing wall (cannot
support the weight of the full tank).
First fit the water heater on its tripod in order to mark
the mounting points.
Carry out the drilling.
Put the water heater back in place.
Mount the upper bracket.
3.2 Vertical water heater on base
Fitting a vertical water heater on a base (fig.
does not require mounting.
Make sure you fit it on a flat surface.
You can use a riser (fig.
3.3 Horizontal wall-mounted water heater - Underside connection
A horizontal water heater can be fitted to the wall, ceiling or floor.
The cold water inlet and the hot water outlet must always be at the bottom.
È
Leave a free space of 400 mm underneath the cover in case the heater element in case the heater element
needs to be replaced.
38
v
) to facilitate routing of the pipes.
u
)
u
È
v
È