Publicité
Les langues disponibles
Les langues disponibles
Produktgruppen 512, 592
9 von 34
Drill 4 holes 12 mm Ø approx. 65 mm deep in the floor as shown, Fig. 3.
Insert 4 S12 Rawl plugs flush in the holes, Fig. 4, Pos. 1.
Fit spacer plates,Fig. 4, Pos. 2 as appropriate and use the spirit level to level the plinth.
Secure the plinth with four 8 x 65 hexagon head wood screws,Fig. 4, Pos. 3, 8.4 washers,
Fig. 4, Pos. 4 and 38 mm Ø washers,Fig. 4, Pos. 5, to the floor.
Place the machine on the plinth.
Danger!
Risk of injury, particularly to the back. The relation of the weight of the machine to the physical strength of the
technician must be taken into account. For machine weight details, see the appropriate operating instructions.
Risk of crushing. When carrying out work, ensure that parts of the body, especially the hands and feet are not
positioned under or between machines.
Fit 4 clamps,Fig. 6, Pos. 1over the machine feet.
Insert four M6 bolts,Fig. 6, Pos. 2, with B6.4 galvanised washers,Fig. 6, Pos. 3, from above through the
existing holes.
Secure the 4 clamps from below with 38 mm Ø washers, Fig. 6, Pos. 4, B6.4 galvanised washers, Fig. 6,
Pos. 3, and M6 nuts, Fig. 6, Pos. 5, tightened from below.
Danger!
Risk of toppling and falling! It is absolutely essential to secure the plinth to the floor and the machine to the
plinth.
Note
For details of the drain connection in the floor or wall, see the PW 5105 installation plan.
Note
Fixing materials for a floating screed floor are to be provided on site.
UG 5010 plinth
Fit the 2 side panels with M4 x 12.4 raised-head screws (Torx 20), Fig. 7.
Fit the 2 side panels with M4 x 12.4 raised-head screws (Torx 20), Fig. 7.
Carry out appropriate safety checks.
Reconnect the machine to the mains.
Carry out a functional test either with the service programme or a wash programme. Check the drain
connection from the machine to the on-site drain in the floor or wall for leaks.
en
06.01.2011
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 09059270
Publicité
