Miele PW 5105 Mode D'emploi page 7

Produktgruppen 512, 592
7 von 34
en
Parts required
Quantity Mat. no.
1 09038900
1 09038870
Note
Service and repair work should only be carried out by a suitably qualified electrician (with specialist training,
knowledge and experience, and recent related work experience) in accordance with all appropriate local and
national safety regulations.
Servicing, modification, testing and maintenance of electrical appliances should only be carried out in
accordance with all appropriate legal requirements, accident prevention regulations and valid standards. All
regulations of the appropriate utility supply companies and standards relating to safety (not limited to electrical
safety) are to be complied with.
Danger!
Even with the machine switched off, mains voltage may be applied to some components.
Before any service work is commenced, the machine must be disconnected from the mains. Suitable
measurements must be made to ensure that this is the case.
A general visual check should always be carried out.
Incorrect conversion or service work could lead to a risk of fire or gas explosion.
Danger!
Risk of injury during fitting
Risk of electric shock. Before any service work is commenced, the machine must be disconnected from
the mains.
Fitting can only be carried out with the washing machine or tumble dryer not installed. For deinstallation,
see the appropriate operating instructions.
Risk of pinching. Wear slip-proof working gloves and safety shoes.
Risk of pinching. When carrying out work, ensure that parts of the body, especially the hands and feet
are not positioned under or between machines.
Risk of accident. Ensure that children or pets cannot access the work area while fitting work is being
carried out.
Risk of injury, particularly to the back. The relation of the weight of the machine to the physical strength
of the technician must be taken into account. For machine weight details, see the appropriate operating
instructions.
Risk of toppling over. Risk of injury due to incorrect fitting.
Always bolt the machine to the plinth.
With a single machine installation, secure the plinth to the floor with the fastening accessory,
Mat. no. 01497252. This is supplied with the kit.
With floor fastening, secure all four plinth feet.
The plinth must not be used with a washer-dryer stack.
06.01.2011 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
Designation
Fitting kit - Plinth UO 5010
Fitting kit - Plinth UG 5010
M.-Nr. 09059270