Using The Remote Control - Sharp GS-XP9FGR Notice D'utilisation

USING THE REMOTE CONTROL

LOADING BATTERIES
1
Remove the remote control
cover.
2
Insert batteries in the compart-
ment, making sure the ± and
— polarities are correctly
aligned.
• The display indicates "AM
6:00" when batteries are prop-
erly installed.
3
Reinstall the cover.
NOTES:
• The battery life is approximately one year in normal use.
• When you replace the batteries, always change both batteries, and make sure they
are the same type.
• If the remote control does not operate properly after replacing the batteries, take
out the batteries and reinstall them again after 30 seconds.
• If you will not be using the unit for a long time, remove the batteries from the remote
control.
HOW TO USE THE REMOTE CONTROL
Point the remote control towards the unit's signal receiver window and
press the desired button. The unit generates a beep when it receives the
signal.
• Make sure there is no cur-
tain or other object between
the remote control and the
unit.
• The remote control can send
signals from up to 7 metres
away.
Use two size-AAA (R03) batteries.
E-6
Remote control
cover
-
+
+
-