Factory Reset - Siemens TI351 Série Mode D'emploi

en Settings
Touch % button and select the
4.
water hardness.
The following settings are possible:
W. hardness 1
W. hardness 2
W. hardness 3
W. hardness 4 (factory setting)
Water filter (when used)
H2O-softener (if available)
Touch espresso button to save the
5.
setting.
Touch calc'nClean button to exit the
6.
menu.
The table shows the allocation of the
levels to the different degrees of water
hardness:
Setting Degree of water hardness
German (°dH)
1 1-7
2 8-14
3 15-21
4 22-30
Subsequent changes to the water
hardness can be made at any time.
When using the water filter (see
Note:
section "Accessories"), proceed as
follows. ~ "Water filter" on page 16
18
French (°fH)
1-13
14-25
26-38
39-54

Factory reset

If you set the appliance back to the
factory settings, you will lose your own
settings.
Simultaneously hold down %
1.
and calc'nClean for at least
3 seconds.
Touch latte macchiato button.
2.
The factory settings are reactivated.
Touch calc'nClean button to exit the
3.
menu.