Optional Rear Filler; Test Run - LG LSE4617 Série Manuel Du Propriétaire

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

16 INSTALLATION

Optional rear Filler

If the counter does not bridge the opening at the rear
wall the rear filler kit, provided with the slide in range,
will be needed.
NOTE
If the countertop depth is greater than 25" there
will be a gap between the filler kit and the back
wall.
If the countertop depth is less than 24", the control
panel will not sit flush with the countertop.
Installing the rear Filler
1
Using a screwdriver, remove the six screws
holding the rear bracket in place and remove the
bracket.
2
Attach the rear filler to the range back, sliding
the hooks into the slots as shown. Slide the rear
bracket into the bottom opening in the rear filler.
Rear bracket
Remove
Rear filler
hook
3
Attach the rear bracket and filler assembly as
shown, using four of the six screws removed in
step 1.
4
Store the remaining two screws with these
instructions for future use.

Test run

Check if the range is properly installed and run a test
cycle.
1
Turn the oven mode knob to the Off position to
start test.
2
Fill an induction-capable pot with water and
place it on a surface element. Turn on the
surface element. The LED bar should show the
setting and the water should heat. The LED
bar should not fluctuate. Repeat for all surface
elements.
3
After checking all the surface heating elements,
check the locking system by pressing
Probe(LSE4617 Model only) or Clock for three
seconds. The oven door should lock and the
cooktop should not operate while the Lockout
function is turned on. Press Probe(LSE4617
Model only) or Clock for three seconds to
disable Lockout.
4
Now check the oven's operation. Turn the oven
mode knob to select the Bake mode. 350 °F
appears in the display. Press Start.
5
The oven should finish preheating in 15 minutes,
and the convection fan should operate while the
oven is preheating.
6
After checking the oven's operation, turn the
temperature up to 450 °F and leave the oven on
for at least an hour to help remove any oil which
might cause smoke and odors when first using
the oven.
NOTE
Smoke may come out of the range when it is first
used.
Slot
Lower screws

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Lse4616 sérieLse4617 serieLse4616 serie

Table des Matières