Ryobi P135 Manuel D'utilisation page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 Make sure the power supply is normal household voltage,
120 volts, AC only, 60 Hz.
 Connect the charger to a power supply.
 Attach the battery pack to the charger by aligning the
raised ribs on the battery pack with the grooves in the
charger, then slide the battery pack into the charger.
 Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
 Latches should snap into place to ensure charger is
correctly connected.
 Do not place the charger in an area of extreme heat or
cold. It will work best at normal room temperature.
 The battery pack may become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
 After charging is complete, the green LED will remain on
while the charger is in Maintenance mode.
 After completing Maintenance mode, the green LED will
begin fading on/off continuously. This indicates the bat-
tery is fully charged and the charger is in Energy Save
mode.
 Charger will periodically wake from Energy Save mode to
ensure the battery pack remains in a fully charged state.
 To remove the battery pack from the charger, depress
latches and pull up on the battery pack.
 When the battery pack is fully charged, remove it from
the charger.
OPERATION
CHARGING A HOT BATTERY PACK
When using a tool continuously, the battery pack may be-
come hot. A hot battery pack may be placed directly onto
the charger port but charging will not begin until the battery
temperature cools to within acceptable temperature range.
When a hot battery pack is placed on the charger, the orange
LED will begin flashing. When the battery pack cools, the
charger will automatically begin charging.
CHARGING A COLD BATTERY PACK
A cold battery pack may be placed directly onto the charger
port but charging will not begin until the battery temperature
warms to within acceptable temperature range. When a cold
battery pack is placed on the charger, the orange LED will
begin flashing. When the battery pack warms, the charger
will automatically begin charging.
5 — English

Publicité

Table des Matières
loading

Table des Matières