Replacing The Aquaclean Filter - Philips SAECO INCANTO HD8922 Mode D'emploi

AQUA CLEAN
FILTER
0 / 8
ON
OFF
0 / 8
AQUA CLEAN
FILTER
1 / 8

Replacing the AquaClean filter

1 For instructions on how to place the AquaClean filter in the water tank,
see the separate quick start guide.
Note: Shake the AquaClean filter for about 5 seconds, immerse it upside
down in a jug with cold water and wait until no more air bubbles come
out.
2 Press the MENU button, select MENU and press the OK button to
confirm. Scroll to AQUACLEAN FILTER. Press the OK button to confirm.
-
The display shows the number of AquaClean filters that have been
installed previously from 0 to 8 filters.
3 Select ON on the display, press the OK button to confirm.
4 The display automatically updates the number of filters used.
-
Then the 'machine ready' screen appears with the AquaClean 100%
icon to indicate that the filter has been installed.
5 Dispense 2 cups of hot water (0.5 l) to complete the activation. Discard
this water.
Note: Replace the AquaClean filter as soon as the capacity has dropped to
0% and the filter icon flashes quickly. Replace the AquaClean filter at least
every 3 months, even if the machine has not yet indicated that replacement
is required.
Tip: We advise you to buy a new filter when the capacity has dropped to
10% and the filter icon starts flashing slowly. This ensures that you can
replace the filter when the capacity has dropped to 0%.
1 Take out the AquaClean filter and replace it by a new AquaClean filter
(also see the separate quick start guide).
English
7