Side Broom Disassembly/Assembly - Nilfisk ALTO Manuel D'utilisation

SIDE BROOM DISASSEMBLY/ASSEMBLY

CAUTION!
It is advisable to wear protective gloves when
replacing the brooms because there can be sharp
debris between the bristles.
Disassembly
1. Place the machine in a suitable place, with the bottom side
up.
2. Remove the screw (A, Fig. 3), and keep the washer (B)
and the bearings (C) for reassembly.
3. Remove the driving belt (D) and the side broom (E).
4. Replace the side broom.
Assembly
5. Assemble the side broom in the reverse order of
disassembly, and note the following:
• Install the driving belt (F, Fig. 4) as shown.
• Turn the knobs fully clockwise.
After installation, check the sweeper operation by testing the
rotation direction of the brooms (14).
1464361000(1)2009-11 A
USER MANUAL
D
E
Figure 3
F
F
Figure 4
FLOORTEC 480M
ENGLISH
C
C
B
A
7