Electric Installation - Cata ControlAir C1-T600 Instructions Pour L'installation, L'utilisation, L'entretien

EN
Make sure the maximum air extraction flow rate for the appliances in the room does not exceed
4 Pa (0.04 mbar).The room must have adequate ventilation if an extractor hood is used simul-
taneously with appliances that run on gas or other fuels. The evacuated air must be extracted
through ducts that are used for evacuating fumes from appliances that run on gas or other
fuels. Regulations regarding air extraction must be complied with.
This product in intended for HOUSEHOLD USE only.
Use a rigid PVC pipe with a min. Ø l20 mm to evacuate fumes outside.
The above restrictions do not apply to hoods with no fumes outlet to outside (recirculation
system with activated charcoal filter).
Warning: Failure to install the screws or fixing device in accordance with these instructions
may result in electrical hazards.
Installation and connection
- This appliance is only intended for domestic use.
- Please observe the special installation instructions.
- The appliance is fitted with a plug and must only be connected to a properly installed earthed socket.
- The mains voltage must correspond to the voltage specified on the rating plate.
- The socket must be installed and connecting cable must only be replaced by a qualified
electrician.If the plug is no longer to accessible following installation,an all-pole disconnecting
device must be present on the installation side with a contact gap of at lease 3mm.
- Adapters,multi-way strips and extension leads must not be used. Overloading can result in a risk of fire.
Warning: This is a Class I appliance and MUST be earthed.
This appliance is supplied with a 3 core mains cable coloured as follows:
• Brown = L or Live
• Blue = N or Neutral
• Green and Yellow = E or Earth
SUCTION VERSION
If the hood is to be installed as a SUCTION hood, connect the plastic outlet piece supplied with
the hood pipe for better performance and lower noise levels.
FILTERING VERSION (INTERNAL RE-CYCLING)
When there is no exhaust duct for venting out-door, you can use a carbon filter. The air is depu-
rate by the filter and put again in the surrounding.
The air is released in the room through a connecting pipe, which goes through the hanging
cupboard and us connected to the connecting ring supplied.
To use the appliance in this version, proceed as follows:
1. Open the grids / 2. Place the carbon filter / 3. Reinstall the grids.
22

ELECTRIC INSTALLATION